ZyXEL Communications ZyWall Reference Manual page 100

Chapter 8 Route
Table 43 Input Values for General Policy Route Commands (continued)
LABEL
policy_number
schedule_object
service_name
user_name
destv6
prefix
gatewayv6
ipv6_addr
ipv6_global_address
ipv6_link_local
The following table describes the commands available for policy route. You must use the
configure terminal
commands.
Table 44 Command Summary: Policy Route
COMMAND
[no] bwm activate
policy {policy_number | append | insert
policy_number}
[no] auto-destination
[no] auto-disable
[no] bandwidth <1..1048576> priority
<1..1024> [maximize-bandwidth-usage]
[no] deactivate
[no] description description
[no] destination {address_object|any}
100
DESCRIPTION
The number of a policy route. 1 - X where X is the highest number of policy routes
the ZyWALL model supports. See the ZyWALL's User's Guide for details.
The name of the schedule. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
The name of the service (group). You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
The name of a user (group). You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
The IPv6 route prefix (subnet address) for the destination.
The IPv6 prefix length, 0 - 128.
The IPv6 address of the specified gateway.
An IPv6 address.
An IPv6 address excluding the link-local address (fe80::).
An fe80:: IPv6 address.
command to enter the configuration mode before you can use these
DESCRIPTION
Globally enables bandwidth management. You must globally activate
bandwidth management to have individual policy routes or application
patrol policies apply bandwidth management. The no command
globally disables bandwidth management.
Enters the policy-route sub-command mode to configure, add or insert
a policy.
When you set tunnel as the next-hop type (using the next-hop
tunnel command) for this route, you can use this command to have
the ZyWALL use the local network of the peer router that initiated an
incoming dynamic IPSec tunnel as the destination address of the policy
instead of what you configure by using the destination command.
The no command disables the setting.
When you set interface or trunk as the next-hop type (using the
next-hop interface or next-hop trunk command) for this route,
you can use this command to have the ZyWALL automatically disable
this policy route when the next-hop's connection is down. The no
command disables the setting.
Sets the maximum bandwidth and priority for the policy. The no
command removes bandwidth settings from the rule. You can also turn
maximize bandwidth usage on or off.
Disables the specified policy. The no command enables the specified
policy.
Sets a descriptive name for the policy. The no command removes the
name for the policy.
Sets the destination IP address the matched packets must have. The
no command resets the destination IP address to the default (any).
any means all IP addresses.
ZyWALL (ZLD) CLI Reference Guide