Log Entries Commands; System Log Commands - ZyXEL Communications ZyWall Reference Manual

Chapter 40 Logs

40.1.1 Log Entries Commands

This table lists the commands to look at log entries.
Table 187 logging Commands: Log Entries
COMMAND
show logging entries [priority pri] [category
module_name] [srcip ip] [srcip6 ipv6_addr]
[dstip ip] [dstip6 ipv6_addr] [service
service_name] [begin <1..512> end <1..512>]
[keyword keyword] [srciface interface_name]
[dstiface interface_name] [protocol protocol]
show logging entries field field [begin
<1..512> end <1..512>]

40.1.2 System Log Commands

This table lists the commands for the system log settings.
Table 188 logging Commands: System Log Settings
COMMAND
show logging status system-log
logging system-log category module_name
{disable | level normal | level all}
[no] logging system-log suppression
interval <10..600>
[no] logging system-log suppression
[no] connectivity-check continuous-log
activate
show connectivity-check continuous-log
status
clear logging system-log buffer
318
DESCRIPTION
Displays the specified entries in the system log.
pri: alert | crit | debug | emerg | error | info | notice | warn
keyword: You can use alphanumeric and
characters, and it can be up to 63 characters long. This searches
the message, source, destination, and notes fields.
Displays the specified fields in the system log.
field: time | msg | src | dst | note | pri | cat | all
DESCRIPTION
Displays the current settings for the system log.
Specifies what kind of information, if any, is logged in the system log and
debugging log for the specified category.
Sets the log consolidation interval for the system log. The no command
sets the interval to ten.
Enables log consolidation in the system log. The no command disables log
consolidation in the system log.
Has the ZyWALL generate a log for each connectivity check. The no
command has the ZyWALL only log the first connectivity check.
Displays whether or not the ZyWALL generates a log for each connectivity
check.
Clears the system log.
()+/:=?!*#@$_%-
ZyWALL (ZLD) CLI Reference Guide