HP Integrity rx2620 User's & Service Manual page 192

Utilities
Specifying SCSI Parameters
• cntrl_handle is the handle of the controller for the channel whose SCSI ID you want to
display or change
So, continuing the example for channel A of this SCSI interface, you would type:
drvcfg -s 45 18
Step 5. The EFI SCSI Setup Utility starts and its main menu is displayed, showing a list of all the EFI
capable SCSI interfaces in the server.
Move the cursor to highlight the channel of the SCSI interface; press
channel of the interface to highlight, match the PCI Bus, PCI Dev, and PCI Func values on this
screen to the Bus #, Dev #, and Fnc # values from the info io command.)
CAUTION
TIP
Step 6. The "Adapter Properties" screen for this channel of the SCSI interface is displayed. If you like, you
can make sure the utility is running for the channel of the SCSI interface by comparing the values
shown for PCI Bus, PCI Device, and PCI Function to the Bus #, Dev #, and Fnc # values from
the info io command.
CAUTION
CAUTION
192
Do not select the <Global Properties> option on the main menu.
To move the cursor in the EFI SCSI Setup Utility, you can use these keys:
↑ ↓ ← →
• Arrow keys:
• Alternate keys:
= left
H
= down
J
= up
K
= right
L
= home
I
= end
O
Do not change the value for any of these fields on the "Adapter Properties" screen:
•
Auto Termination
•
SCSI Parity
•
SCSI Bus Scan Order
•
Spinup Delay (Secs)
Changing any of these fields can cause unpredictable results.
Do not change the value for any of these fields on the "Device Properties" screen:
. (To determine which
Enter
Appendix C