HP Integrity rx2620 User's & Service Manual page 174

Utilities
EFI/POSSE Commands
threads : Use to display info or configure threads
on|off : Specifies to configure or deconfigure a cpu module or threads
Note:
1. Cpu status will not change until next boot.
2. Specifying a cpu number without a state will display
configuration status.
Examples:
* To deconfigure CPU 0
fs0:\> cpuconfig 0 off
Cpu will be deconfigured on the next boot.
* To display configuration status of cpus
fs0:\> cpuconfig
PROCESSOR MODULE INFORMATION
# of
CPU Logical
Module CPUs
------ -------
0 2
1 2
* To display cpu thread status
fs0:\> cpuconfig threads
cpuconfig: Threads are turned off.
* To enable cpu threads
fs0:\> cpuconfig threads on
cpuconfig: Threads will be on after a reset
* To disable cpu threads
fs0:\> cpuconfig threads off
cpuconfig: Threads will be off after a reset
Example C-5 help ioconfig Command
Shell> help ioconfig
Deconfigure or reconfigure IO components or settings
IOCONFIG [fast_init|wol [on|off]]
fast_init Specifies device connection policy setting
wol Specifies System Wake-On-LAN setting
on|off Specifies to configure or deconfigure a feature or component
Note:
1. If fast_init is enabled, firmware will connect only the minimum set of
devices during boot.
feature if failure occurs.
2. Any pending Wake-On-LAN request will not be cleared until reboot if
the setting is changed to disabled.
System will clear pending Wake-On-LAN requests each time the system
reboots if the setting is disabled.
Examples:
* To display the current settings
fs0:\> ioconfig
174
L3 L4
Cache Cache
Speed Size Size
-------- ------ ------
1.1 GHz 4MB 32MB
1.1 GHz 4MB 32MB
This feature might cause boot failure; disable this
Family/
Model Processor
(hex.) Rev State
------- --- ------------
1F/01 B1 Active
1F/01 B1 Active
Appendix C