Server Authentication - Honeywell VX6 Reference Manual

Cisco Radio

Server Authentication

To validate the server certificate install the root CA certificate. For instructions for installing, see
"Root Certificates", later in this chapter.
Navigate to the Wireless Network Properties configuration screen.
Click the Properties button.
Check the Validate server
Click OK to dismiss the configuration boxes.
Once the authentication completes, the status changes to show the VX6 has authenticated to the
<SSID>, as shown in the figure above.
Click on the IP Information tab and make sure there is a valid IP address as shown in the figure
labeled "IP Information Tab", earlier in this chapter.
E-EQ-VX6RG-F
Figure 5-47 Authentication Settings, Validate Server
Figure 5-48 Advanced Wireless Settings, Authenticated SSID
231
VX6 Reference Guide