Step 13: Start Key Output Thread - Honeywell VX6 Reference Manual

Barcode

Step 13: Start Key Output Thread

Access:
If key output is enabled, on the main tab, a thread is started to output the keys.
Access:
If "Translate All" is checked and "Send Key Messages" is checked, unprintable ASCII characters
are assigned to their appropriate 2 keystroke CTRL code sequence (CTRL + letter) when the
barcodes are sent in Key Message mode.
When "Translate All" is not checked and "Send Key Messages" is checked, any CTRL code
which has a keyboard equivalent is passed as a keystroke (enter, tab, escape, backspace, etc.); any
CTRL code which does not have a keyboard equivalent is dropped.
In Block mode ("Send Key Messages" is not checked) CTRL codes are always passed through as
a single CTRL code value.
E-EQ-VX6RG-F
Start | Settings | Control Panel | Scanner | Main
Figure 4-20 Enable Key Messages
Start | Settings | Control Panel | Scanner | Barcode | Ctrl Char
Mapping
Figure 4-21 Control Characters, Translate All
173
VX6 Reference Guide