Table of Contents
Advertisement
3.
First, insert the top of DIN rail clip onto the piece of DIN rail track.
4.
Then, lightly push the bottom of the switch so it can snap the rest of the way onto the
DIN rail track.
5.
Check that the switch is held tightly to the DIN rail track.
6.
To remove the switch from the track, reverse above steps.
• First pushing down lightly on the switch will give enough room for the bottom of
the switch to clear the bottom of the DIN rail track.
• Pulling slowly at the bottom of the switch will bring the switch out so that the
switch can now be carefully lifted off the DIN rail track
14
Manual Documentation Number EIRP610-2SFP-T – 0912m
Hardware Installation
www.bb-elec.com
www.bb-europe.com
Advertisement
Table of Contents
