Table of Contents
Advertisement
Netstar Commands
stp-path-priority
[Port Priority]
stp-admin-p2p
[Auto|True|False]
stp-admin-edge
[True|False]
stp-admin-non-stp
[True|False]
show spanning-tree
128
Level Description
Protocol (STP)
calculations. In the event
of a loop, spanning tree
considers the path cost
when selecting
an interface to place into
the forwarding state.
I
Use the spanning-tree
port-priority interface
configuration command
to configure a port
priority that
is used when two
switches tie for position
as the root switch.
I
Admin P2P of STP
priority on this interface.
Admin Edge of STP
I
priority on this interface.
I
Admin NonSTP of STP
priority on this interface.
E
Displays a summary of
the spanning-tree states.
Manual Documentation Number EIRP610-2SFP-T – 0912m
Command Sets
Example
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-priority
128
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-p2p
Auto
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-edge
True
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-non-stp
False
switch>show spanning-tree
www.bb-elec.com
www.bb-europe.com
Advertisement
Table of Contents
