Rm1D Remotes And External Analogue I/O D-Type Pin-Outs; Remotes 2; 25Wy D-Type Fml; Remotes 1 - SoundCraft RM1ds User Manual

RM1d/RM1ds User Guide
RM1d Remotes and Exter RM1d Remotes and Exter
RM1d Remotes and Exter RM1d Remotes and External Analogue I/O RM1d Remotes and Exter
D-T D-T ype Pin-Outs ype Pin-Outs
D-T D-Type Pin-Outs D-T ype Pin-Outs ype Pin-Outs
Remotes 2 (Remotes 3) Fader Starts
The Fader Start remotes are isolated relay contacts. These can be configured as either momentary
(pulsed) operation or latched via the software.
The contacts are normally open, and can be configured to be closed for Start.
The two terminals of each relay contact are designated A and B below:

25wy D-type FML

Pin Function
1 Chassis Ground
2 Rly 1A
3 Rly 2A
4 Rly 3A
5 Rly 4A
6 Rly 5A
7 Rly 6A
8 Rly 7A
9 Rly 8A
10 Rly 9A
11 Rly 10A
12 Rly 11A
13 Rly 12A
NOTE: It is important that no two devices are assigned to the same relays simultaneously
as this may cause the RM1d to malfunction

Remotes 1

(Master Remotes)
The Master Remotes comprise dedicated normally open relay contacts which operate from the
Studio and Control Room (CRM) mute logic, and hence can be used for 'On Air' Light control.
An additional 4 normally open contacts can be assigned to control various functions from
within the software. The two terminals of each relay contact are designated A and B below:
There are also 4 Remote Inputs, which are high-impedance logic lines that must be pulled low
(to Logic Ground) via an external switch, to activate. The functions of each Remote Input are
assignable from within the software.
nal Analogue I/O nal Analogue I/O
nal Analogue I/O nal Analogue I/O
Pin Function
14 Rly 1B
15 Rly 2B
16 Rly 3B
17 Rly 4B
18 Rly 5B
19 Rly 6B
20 Rly 7B
21 Rly 8B
22 Rly 9B
23 Rly 10B
24 Rly 11B
25 Rly 12B
133