Table of Contents
Advertisement
106
Applying the Effect to a Signal
Once you have chosen the desired effect you will want to apply it to one or more of the channel
signals in order to hear how it sounds.
1.
Press the EDIT button on the channel to which you want to apply the effect. (This will
select the EDIT STRIP to the channel)
2.
Make sure that the FX IN button is seleceted
3.
Now turn up the AUX 1 or AUX 2 control (depending on which one you selected as
the source)
4.
You should now begin to hear the effect on your monitor speaker or headphones
5.
Use the AUX 1 or AUX 2 send control to vary the amount of effect you require.
Editing, Storing and Renaming an Effect
It is possible to edit the parameters of any of the preset effects to suit your own individual
requirements.
1.
Start by selecting an effect from the presets menu that is close to what you want.
2.
Press the FX EDIT button
3.
Now use the DOWN/UP arrow keys to step through the various parameters. The
PARAMETER encoder is use to adjust the parameter value.
4.
Once you are happy with the new edited effect press the flashing PRESETS button.
5.
Use the DOWN arrow button to select the 'FX Preset Recall' line of the LCD Display
6.
Use the PARAMETER encoder to select 'FX Preset Store'
7.
Now press the flashing PRESETS button
8.
The LCD Display will now read
9.
Confirm the storing procedure by pressing the flashing FX EDIT button (or cancel by
pressing the PRESETS button)
RM1d/RM1ds User Guide
Advertisement
Table of Contents
