Input Naming; Naming An Input Source - SoundCraft RM1ds User Manual

RM1d/RM1ds User Guide

Input Naming

Input Naming
Input Naming Input Naming Input Naming
Any of the inputs discussed in Chapter 2 'Assign Channel', can be given a personalised name
if required.
This is very useful for example in permanent set-ups where the inputs to the console do not
change often.
If a CD player is connected to AES/EBU 1 then the display name could be changed from AES
1 to read CD 1.
Microphone inputs could also be renamed in this way to show for example the presenter's
name.
NOTE: The naming of inputs is limited to 4 characters.

Naming an Input Source

1 Press the SETUP button found below the LCD display.
This will enter the SETUP mode
2 Use the PARAMETER encoder to scroll through the menu pages to locate the INPUT
NAMING menu.
The SETUP button will flash upon selection.
3 Press the SETUP button to enter the INPUT NAMING mode.
The LCD display will now show the currently selected input and next to it the current
name of that input for example:
4 Use the LEFT/RIGHT arrow buttons to select the left hand field of the LCD display
and then using the PARAMETER (ENCODER) scroll through the different input sources
until you find the one you want to rename.
5 Now use the LEFT/RIGHT arrow buttons to select one of the four characters on the
right side of the LCD display.
7 You may now use the PARAMETER encoder to scroll alphanumerically through all of
the available character choices.
You can also use the UP arrow button to increment through numbers, and the DOWN
arrow button to delete the currently selected character or create a space.
8 Press the SETUP button to exit the Menu page.
67