Using The Access Point Setup Wizard - Cisco WAP371 Administration Manual

Getting Started

Using the Access Point Setup Wizard

Using the Access Point Setup Wizard
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business WAP371 Wireless Access Point Administration Guide
address can also be specified as the subnet IP address, so that all addresses in the
subnet are added to the local intranet zone.
• If you have multiple IPv6 interfaces on your management station, use the IPv6 global
address instead of the IPv6 local address to access the AP from your browser.
Logging Out
By default, the web-based AP configuration utility logs out after 10 minutes of inactivity. See
HTTP/HTTPS Service for instructions on changing the default timeout period.
To log out, click Logout in the top right corner of the web-based AP configuration utility.
The first time that you log into the AP (or after it has been reset to the factory default settings),
the Access Point Setup Wizard appears to help you perform initial configurations. Follow
these steps to complete the wizard:
If you click Cancel to bypass the Wizard, the Change Password page appears. You can then
change the default password for logging in. For all other settings, the factory default
configurations apply.
You must log in again after changing your password.
Click Next on the Welcome page of the Wizard. The Configure Device - IP Address window
appears.
Click Dynamic IP Address (DHCP) if you want the WAP device to receive an IP address from
a DHCP server. Or select Static IP Address to configure IP Address manually. For a
description of these fields, see
Click Next. The Single Point Setup — Set a Cluster window appears. For a description of
Single Point Setup, see Single Point
To create a new Single Point Setup of WAP devices, select Create a New Cluster and specify a
New Cluster Name. When you configure your devices with the same cluster name and enable
Single Point Setup mode on other WAP devices, they automatically join the group.
VLAN and IPv4 Address
Setup.
Settings.
1
3