Targets - Cisco WAP371 Administration Manual

Simple Network Management Protocol

Targets

STEP 5
NOTE
Targets
NOTE
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
NOTE
Cisco Small Business WAP371 Wireless Access Point Administration Guide
Click Save. The user is added to the SNMPv3 Users list and your changes are saved to the
Startup Configuration.
To remove a user, select the user in the list and click Delete.
SNMPv3 targets send SNMP notifications using Inform messages to the SNMP Manager. For
SNMPv3 targets, only Informs are sent, not traps. For SNMP versions 1 and 2, traps are sent.
Each target is defined with a target IP address, UDP port, and SNMPv3 user name.
SNMPv3 user configuration (see the
SNMPv3 targets.
The AP supports a maximum of eight targets.
To add SNMP targets:
Select SNMP > Targets in the navigation pane.
Click Add. A new row is created in the table.
Check the box in the new row and click Edit.
Configure the parameters:
• IP Address—Enter the IPv4 address of the remote SNMP manager to receive the target.
• UDP Port—Enter the UDP port to use for sending SNMPv3 targets.
• Users—Enter the name of the SNMP user to associate with the target. To configure
SNMP users, see the
Click Save. The user is added to the SNMPv3 Targets list and your changes are saved to the
Startup Configuration.
To remove an SMMP target, select the user in the list and click Delete.
Users page) should be completed before configuring
Users page.
8
127