Using The Access Point Setup Wizard - Cisco Small Business WAP551 Administration Manual

Getting Started

Using the Access Point Setup Wizard

Using the Access Point Setup Wizard
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
address>) to the local intranet zone. The IP address can also be specified
as the subnet IP address, so that all addresses in the subnet are added to
the local intranet zone.
• If you have multiple IPv6 interfaces on your management station, use the
IPv6 global address instead of the IPv6 local address to access the WAP
device from your browser.
By default, the web-based AP configuration utility logs out after 10 minutes of
inactivity. See HTTP/HTTPS Service
timeout period.
To log out, click Logout in the top right corner of the web-based AP configuration
utility.
The first time that you log into the WAP device (or after it has been reset to the
factory default settings), the Access Point Setup Wizard appears to help you
perform initial configurations. Follow these steps to complete the wizard:
If you click Cancel to bypass the Wizard, the Change Password page appears. You
can then change the default password for logging in. For all other settings, the
factory default configurations apply.
You must log in again after changing your password.
Click Next on the Welcome page of the Wizard. The Configure Device - IP
Address window appears.
Click Dynamic IP Address (DHCP) if you want the WAP device to receive an IP
address from a DHCP server. Or select Static IP Address to configure IP Address
manually. For a description of these fields, see
Click Next. The Single Point Setup — Set a Cluster window appears. For a
description of Single Point Setup, see
To create a new Single Point Setup of WAP devices, select Create a New Cluster
and specify a New Cluster Name. When you configure your devices with the
same cluster name and enable Single Point Setup mode on other WAP devices,
they automatically join the group.
for instructions on changing the default
VLAN and IPv4 Address
Single Point Setup.
1
Settings.
6