Client Qos Association - Cisco WAP371 Administration Manual

Client Quality of Service

Client QoS Association

STEP 7
NOTE
NOTE
NOTE
Client QoS Association
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business WAP371 Wireless Access Point Administration Guide
• Disassociate Class Map—Removes the class selected in the Class Map Name list from
the policy selected in the Policy Map Name list.
• Member Classes—Lists all DiffServ classes currently defined as members of the
selected policy. If no class is associated with the policy, the field is empty.
Click Save. The changes are saved to the Startup Configuration.
To delete a policy map, select it in the Policy Map Name list and click Delete.
A policy map can only be deleted when it is not associated to any VAP.
The policy marking paramaters like Mark Class of Service, Mark IP DSCP and Mark IP
Precedence are not supported for IPV6 Class Map.
The Client QoS Association page provides additional control over certain QoS aspects of
wireless clients that connect to the network, such as the amount of bandwidth an individual
client is allowed to send and receive. To control general categories of traffic, such as HTTP
traffic or traffic from a specific subnet, you can configure ACLs and assign them to one or
more VAPs.
In addition to controlling general traffic categories, Client QoS allows you to configure per-
client conditioning of various micro-flows through Differentiated Services (DiffServ).
DiffServ policies are a useful tool for establishing general micro-flow definition and treatment
characteristics that can be applied to each wireless client, both inbound and outbound, when it
is authenticated on the network.
To configure client QoS association parameters:
Select Client QoS > Client QoS Association in the navigation pane.
Select the radio interface on which you want to configure the association (Radio 1 or Radio 2).
From the VAP list, select the VAP on which you want to configure client QoS parameters.
Select Enable for the Client QoS Global to enable this feature.
Configure these parameters for the selected VAP:
• Client QoS Mode—Select Enable to enable client QoS functionality on the selected
VAP.
7
116