Client Qos Association - Cisco WAP121 Administration Manual

Client Quality of Service

Client QoS Association

STEP 6
Client QoS Association
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
Click Save. The changes are saved to the Running Configuration and to the Startup
Configuration.
NOTE: To delete a policy map, select it in the Policy Map Name list and click
Delete.
The Client QoS Association page provides additional control over certain QoS
aspects of wireless clients that connect to the network, such as the amount of
bandwidth an individual client is allowed to send and receive. To control general
categories of traffic, such as HTTP traffic or traffic from a specific subnet, you can
configure ACLs and assign them to one or more VAPs.
In addition to controlling general traffic categories, Client QoS allows you to
configure per-client conditioning of various micro-flows through Differentiated
Services (DiffServ). DiffServ policies are a useful tool for establishing general
micro-flow definition and treatment characteristics that can be applied to each
wireless client, both inbound and outbound, when it is authenticated on the
network.
To configure client QoS association parameters:
Click Client QoS > Client QoS Association in the navigation window.
Select Enable for the Client QoS Global Admin Mode to globally enable this
feature.
From the VAP list, select the VAP on which you want to configure client QoS
parameters.
Configure these parameters for the selected VAP:
• Client QoS Mode—Select Enable to enable client QoS functionality on the
selected VAP.
• Bandwidth Limit Down—The maximum allowed transmission rate from the
WAP device to the client in bits per second (bps). The valid range is from 0
to 4294967295 bps.
• Bandwidth Limit Up—The maximum allowed transmission rate from the
client to the WAP device in bits per second (bps). The valid range is from 0
to 4294967295 bps.
7
126