Nikon D300 User Manual page 500

▪ Disable – The exposure meter stays on the entire time a
GPS unit is connected. As long as you have good GPS
signal, you will be able to record GPS data at any time.
This is the preferred setting for using the GPS for
continuous shooting. It does use extra battery life, so you
may want to carry more than one battery if you're going
to shoot all day.
Here are the steps and screens used to configure the
settings (see Figure
Figure 5-33. GPS Auto meter off enable/disable screens
1. Choose GPS
2. Select Auto meter off
3. Select Enable
4. Press the
There is also a
image 2. If your GPS unit is not attached to the camera, the
Position selection is grayed out. Once a GPS is attached, the
next screen after
being detected by the D300(S), as shown in
When the camera establishes communication with your GPS,
it does three things:
5-33):
from the Setup menu
and scroll to the right.
or Disable.
OK button to lock in the setting.
Position setting, as shown in
Position shows the actual GPS location data
and scroll to the right.
500
GPS
Figure 5-33,
Figure 5-35.