Installing A Pci Card - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Installing a PCI card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support (see
4. Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following
figure
Figure 5-98
5. Lift the slot cover straight up to remove it from the chassis
TIP:
the outside.
152 Chapter 5 Replacing components
.
Removing the slot cover
Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
2
74).
76).
.
78).
ENWW