Panasonic DP-1510P Service Manual page 94

3.4.3. Updating the Host Firmware using a PC via the Parallel Port
1. Before starting, print the F5 & F6 Parameters (Copier) Lists.
2. Connect the machine to the PC with a Parallel Printer Cable.
3. Install the Panasonic Firmware Programming Wizard software to the PC. (Refer to the Firmware
Update Tool Operating Instructions)
4. Perform the Copy Service Mode F9-07-05 (PC → HOST).
Now the machine is ready to accept programming firmware code from the PC.
5. Start the Panasonic Firmware Program using the Wizard.
6. The firmware is copied into the machine.
7. After the update is completed, the machine reboots itself and returns to standby.
8. Perform the Copy Service Mode F9-06-00 (PARAMETER INITIALIZE).
9. Turn the Power Switch to the OFF (O) position.
10. Remove the Master Firmware Card from the machine.
11. Turn the Power Switch to the ON (I) position.
12. Reprogram the F5 & F6 Parameters (Copier) according to the lists printed in Step 1 above if the
settings are other than factory default.
3.4.4. Updating the PDL Board Firmware using the Master Firmware Card
1. Turn the Power Switch to the OFF (O) position.
2. Install the appropriate Master Firmware Card into the machine.
3. Turn the Power Switch to the ON (I) position.
4. Press "FUNCTION", "ORIGINAL SIZE" keys and then Key "3" on the keypad sequentially.
5. Perform the Copy Service Mode F9-07-03 (FIRMWARE UPDATE PDL BOARD <2MB>).
6. The firmware is copied into the PDL PC Board.
7. After the update is completed, the LCD displays "COMPLETE".
8. Check the Update Version with the Copy Service Mode F9-02-05 (PRINTER BOARD (PDL)).
9. Turn the Power Switch to the OFF (O) position.
10. Remove the Master Firmware Card from the machine.
11. Turn the Power Switch to the ON (I) position.
3.4.5. Updating the LAN Board (NIC/i-Fax) Firmware using the Master Firmware Card
1. Turn the Power Switch to the OFF (O) position.
2. Install the appropriate Master Firmware Card into the machine.
3. Turn the Power Switch to the ON (I) position.
4. Press "FUNCTION", "ORIGINAL SIZE" keys and then Key "3" on the keypad sequentially.
5. Perform the Copy Service Mode F9-07-04 (FIRMWARE UPDATE LAN BOARD <2MB>).
6. The firmware is copied into the LAN Board.
7. After the update is completed, the LCD displays "COMPLETE".
8. Check the Update Version with the Copy Service Mode F9-02-06 (LAN BOARD).
9. Turn the Power Switch to the OFF (O) position.
10. Remove the Master Firmware Card from the machine.
11. Turn the Power Switch to the ON (I) position.
Edition 2.0
94
DP-1510P/1810P
/1810F/2010E
APR 2002