Panasonic DP-1510P Service Manual page 297

5.2.4. Service Mode 4 (Modem Test)
5.2.4.1. Binary Signal
This Service Mode is used to check the binary signal output. Signals can be output to the line using the
following procedure.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "4".
Use "V" or "/\ " to scroll to the desired Modem Test.
5 Press "START".
6 Enter the signal number (1-9) to select the binary
signal.
7 Press "CLEAR" to end the signal generation. To select
another signal, repeat step 6.
8 Press "STOP" twice to return to standby.
Edition 2.0
Service Mode 4 for DP-1810F - Binary Signal
Operation or Unit Condition
Binary Signal Table
Number
1 V21 300bps
2 V27ter 2400bps
3 V27ter 4800bps
4 V29 7200bps
5 V29 9600bps
6 V17 TC7200bps
7 V17 TC9600bps
8 V33 12000bps
9 V33 14400bps
Signals
297
DP-1510P/1810P
/1810F/2010E
LCD Display
MMM-dd-yyyy 15:00
00%
SET MODE (1-4)
ENTER NO. OR V
SERVICE MODE
ENTER NO. OR V
MODEM TEST (1-5)
1:SIGNAL TEST
SIGNAL TEST
IDLE (ENTER 1-9)
SIGNAL TEST
300bps
SIGNAL TEST
IDLE (ENTER 1-9)
MMM-dd-yyyy 15:00
00%
APR 2002