System Restart - Panasonic KX-TD816 Installation Manual

2.7

System Restart

Notice
2-78 Installation
After starting the system, if the system does not operate properly,
restart the system.
Before restarting the system, try the system feature again to
confirm whether there definitely is a problem or not.
System Restart causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
Other data except the above are not cleared by System Restart.
1. Make sure that the System Clear Switch is set to the
"NORMAL" position.
2. Press the Reset Button with a pointed tool.
After pressing the Reset Button, if you notice that the System Clear
Switch is set to the "CLEAR" position, never slide the System Clear
Switch to the "NORMAL" position in 20 seconds. Otherwise, all the
system programming data are reset to default values (Refer to Section 2.8
"System Data Clear"). Slide to the "NORMAL" position over 30 seconds
later. Then the system works as before.
If the system still does not operate properly, please see Section 6.1.4
"Using Reset Button."