Animas OneTouch Ping Owner's Booklet page 133

CHAPTER 1 - SETTING UP YOUR ONETOUCH
2
Set your default BG Target
Your BG target represents your goal for achieving good glycemic (BG) control.
To choose a different target, press
press .
The "+/–" field is now highlighted.
3
Set your default +/– (range) value
By setting a range (+/–), your meter remote will not calculate a BG correction
if your actual BG is within that range. If you prefer to correct to a single target
rather than a target range, set your range to "+/– 0". Press
desired BG target range and press
The "IS Factor" field is now highlighted.
4
Set your default Insulin Sensitivity (IS) Factor
"IS Factor" is the approximate amount by which you can lower your BG
level (in mg/dL) with one unit of insulin. You can change your IS Factor by
scrolling to the desired number and pressing
After setting your IS Factor and pressing
Settings screen with "Lock Buttons" highlighted.
WARNING: Bolus units that are computed with the calculator may not take all your other
health factors into consideration. These include:
• Your stress level.
• Whether you plan to exercise.
• Any IOB from a syringe, pen, or pump bolus.
You may always adjust the insulin units up or down before you decide to administer your bolus.
If you dose an insulin amount that is too high or too low, this may result in a hypoglycemic
or hyperglycemic event. Please discuss the bolus calculator feature and all relevant personal
settings with your health care professional before using the calculator for the first time.
® PING ™ METER REMOTE
to select the desired BG Target and
to select the
.
.
, you will return to the Meter
117
Calculator Set-up
I:C Ratio
1U:15 g
BG Target 120 mg/dL
+ / – 10 mg/dL
IS Factor 1U:50 mg/dL
Calculator Set-up
I:C Ratio
1U:15 g
BG Target 120 mg/dL
+ / – 10 mg/dL
IS Factor 1U:50 mg/dL
Calculator Set-up
I:C Ratio 1U:15 g
BG Target 120 mg/dL
+ / – 10 mg/dL
IS Factor 1U:50 mg/dL