Insufficient Paper For Job; This Paper Cannot Be Used; Roll Printing Is Selected; Roll Printing Is Selected, But Sheets Are Loaded - Canon imagePROGRAF iPF765 User Manual

iPF765

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left
when ManageRemainRoll in the Control Panel menu is On.

This paper cannot be used.

This paper cannot be used.
Cause
Paper smaller than the printer's minimum supported size
has been loaded.
Paper has been loaded that is too small to print the test
pattern for printhead adjustment or nozzle checking.

Roll printing is selected.

Roll printing is selected.
Cause
You have attempted to print a test print sheet or other
printer status information on a roll, but no roll is loa-
ded.

Roll printing is selected, but sheets are loaded.

Roll printing is selected, but sheets are loaded.
Cause
A print job for rolls was received when a sheet
is loaded.

The roll is empty.

The roll is empty.
Cause
The roll is empty. Follow these steps to replace the used roll with a new roll of the same type and size.
1.
User's Guide
Cause
Press ▲ or ▼ to select Load Roll Paper, and then press the OK button. Load the
roll, and then print.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
To print on sheets, follow these steps.
1.
2.
(See "Loading and Printing on Sheets.")
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.
(See "Removing Sheets.")
2.
Load a new roll.
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Press the Release Lever back and remove the roll.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
Press ▲ or ▼ to select Print, and then press the OK button
to resume printing.
However, the roll paper may run out during the print job and
you may not be able to print all of the document.
Press ▲ or ▼ to select Change Paper, and then press the
OK button to stop printing.
Either change the printer driver Paper Source setting or the
GL2 Settings > Paper Source setting in the printer menu or
replace the roll with a roll that has enough paper for the print
job, and then try printing again.
(See "Removing the Roll from the Printer.")
(See "Loading Rolls in the Printer.")
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
→P.394
Push the Release Lever back and load unused paper of A4 size or larger.
More than one sheet may be required depending on the adjustment.
Corrective Action
Press ▲ or ▼ to select Stop Printing, and then press the OK button to stop
printing.
Load a sheet and try printing again.
Corrective Action
→P.424
→P.401
Corrective Action
→P.406
→P.408
Insufficient paper for job
Corrective Action
→P.406
→P.401
Corrective Action
→P.399
→P.401
→P.23
629