Cutting The Leading Edge Of Roll Paper Automatically - Canon imagePROGRAF iPF765 User Manual

Cutting the Leading Edge of Roll Paper Automatically

3
Press the Cut button.
4
Press ▲ or ▼ to select Yes, and then press the OK button.
After the roll paper is cut, it is rewound automatically.
Caution

Cutting the Leading Edge of Roll Paper Automatically

Cutting the Leading Edge of Roll Paper Automatically
If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case,
set Trim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut the lead-
ing edge to make the edge straight after you load a roll.
Trim Edge First offers the following options.
• Automatic
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more when
you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are re-
moved. The edge is not cut if the unevenness is less than 3 mm. However, paper may sometimes be cut, de-
pending on the state of the leading edge.This setting is Automatic for most types of paper, by default. For
more information, see the Paper Reference Guide. (See "Types of Paper.")
• Off
The edge is not cut and scraps are not removed.
• On
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from the
leading edge varies depending on the type of paper. For more information, see the Paper Reference Guide.
(See "Types of Paper.")
416
•
If the width of the paper differs, setting Skew Check Lv. to Loose relaxes the accuracy of the paper skew detection
feature, and setting it to Off ignores the skew detection feature. However, when Off is selected and the paper is loaded
Important
skewed, a paper jam may result or the Platen may become soiled.
•
If paper would be short when cut at a particular position, the roll may automatically be advanced in some cases
before cutting.
→P.394
→P.394
User's Guide
iPF765