Display Test Function; Light Control For X-10 Devices; Change Languages; Changing User Codes - Interlogix NX1248 Instruction Manual

DISPLAY TEST FUNCTION

This function will perform a test of the LCD display. No alarms or reports will be
sent.
1. Press [U] [4] [5]. The test will be performed and all of the display pixels and
keys will flash until another key is pressed.
2. Press any key to end the test.
LIGHT CONTROL FOR X-10 DEVICES (Optional, if programmed)
This menu allows you to control up to ten X-10 devices from each keypad.
1. Press [U] [4] [6]. The screen will prompt you to "Select Light Number 0 - 9".
2. Enter the number of the X-10 device you want to control. The LCD screen will
show the light number on the left. On the right side of the display it will
prompt you to turn the light (X-10 device) "On" or "Off".
3. Press [x] to turn the X-10 device "On" or press [y] to turn the X-10 device
"Off".
4. The LCD screen will again prompt you to "Select Light Number 0 - 9".
5. Repeat Steps 2 and 3 until complete.
6. Press [#] to exit from the X-10 menu.

CHANGE LANGUAGES

This function allows you to switch between the two languages programmed in your
keypad. NOTE: You must exit any other function mode before attempting to
change languages.
1. Press [U] [4] [9]. The LCD keypad is now toggled to the second language.
2. Repeat Step 1 to revert to the first language.

CHANGING USER CODES

1. Press [U] [5]. The LCD Screen will prompt for a code.
2. Enter [master code]. The LCD Screen will prompt for a user number. NOTE:
For partitioned systems, if you are changing the code of another person,
you must have access to all partitions, or at least all of the partitions to
which the other person has access.
LCD Keypad
11