Making Your System Ready To Arm; Arming Your System In The "Stay" Mode - Interlogix NX1248 Instruction Manual

delay. The user may wish to
disarm and re-arm the system if
more time is needed.

MAKING YOUR SYSTEM READY TO ARM

If the System Ready message is not displayed, a zone is not secure. To identify
this zone, press [x] [y] to the right of the display to browse through the zones that
are not normal. If you wish to bypass or unbypass one of these zones, press
[BYPASS] while that zone is being displayed. When finished viewing the zones,
press [#] to return to the code entry screen.

ARMING YOUR SYSTEM IN THE "STAY" MODE

STAY is utilized when the user is inside the premise and wants protection around
the perimeter.
1. Close all protected doors and
windows.
T The System Ready message
will be displayed when all protected zones and sensors are secure.
NOTE: If any zones are bypassed, a sensor in that zone can be
violated without affecting the ready status.
T The security system will not arm if the System Not Ready message is
displayed. It can be force armed if the entire System Not Ready message
is flashing. Refer to the following section, "Making Your System Ready
to Arm".
T If the Service Required" message is alternated displayed, you may not
have AC power. Restore power if possible. If not, contact the installing
company.
2. Enter your 4 or 6 digit user code. (Optional, if programmed.)
T If "Auto Bypass" is enabled, all interior zones will be bypassed if you do
not leave through a designated entry/exit door. If Auto Bypass is
enabled, omit Step 3.
3. Press [STAY].
T The [STAY] key will illuminate indicating that all interior zones are
bypassed. (All interior devices will bypass automatically, giving the user
freedom of movement within the interior area.)
6
6\VWHP1RW5HDG\
)RUKHOSSUHVV 
6\VWHP5HDG\
7\SH.RGHWRDUP
LCD Keypad