Keypad Functions; Arming Your System In The "Away" Mode - Interlogix NX1248 Instruction Manual

center. This key should only be pressed in
an emergency situation requiring response
by emergency personnel.
Police (Panic/Hold-Up) Key - If programmed, when the Emergency Activation
[Police] key is pressed for two seconds, a local audible alarm will sound. If your
system is connected to a monitoring center, an emergency report could be
transmitted to that center. These keys should only be pressed in an emergency
situation requiring immediate response by law enforcement personnel. NOTE:
Some Panic/Hold-Up alarms are programmed to be silent at the protected site
while reporting an alarm to the monitoring center. Check with your installing
company to determine how your security system will respond to the Panic/Hold-Up
activation.

ARMING YOUR SYSTEM IN THE "AWAY" MODE

AWAY is utilized when the user is going away from the premise and wants the
interior protected.
1. Close all protected doors and windows.
T The System Ready message will
be displayed when all protected
zones and sensors are secure.
NOTE: If any
bypassed, a sensor in that
zone can be violated without affecting the ready status.
T The security system will not arm if the System Not Ready message is
displayed. It can be force armed if the entire System Not Ready message
is flashing. Refer to the following section, "Making Your System Ready
to Arm".
T If the "Service Required" message is alternately displayed, you may not
have AC power. Restore power if possible. If not, contact the installing
company.
2. Enter your 4 or 6 digit user code to arm the system.
T The [AWAY] key will illuminate steady. The [STAY] and [NIGHT] keys
will flash will flash during the exit delay.
T You may now leave the building.
T The keypad tones will accelerate during the last 10 seconds of the exit
LCD Keypad
)RUKHOSSUHVV 

KEYPAD FUNCTIONS

7\SH&RGHWR$UP
zones are
6\VWHP1RW5HDG\
6\VWHP5HDG\

5