Using The Quick Arm; Disarming Your System - Interlogix NX1248 Instruction Manual

T The [BYPASS] key will illuminate if any zone(s) are bypassed. If any
zone(s) have been bypassed previously by the user, the light(s)
corresponding to the bypassed zone(s) will illuminate, alerting the user
that a zone(s) may be unprotected and can be faulted without an alarm.
4. To toggle between the STAY and NIGHT mode, double press the key
corresponding to the mode you desire.
5. To upgrade from the STAY or NIGHT mode to the AWAY mode, double
press [AWAY]. Note: Once the AWAY mode is activated, the system must
be disarmed to revert to the STAY or NIGHT mode.
T The LCD display will read "Instant"
meaning the entry/exit doors do
NOT have an entry delay.

USING THE QUICK ARM

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system in the AWAY / STAY / NIGHT modes by pressing the
corresponding [AWAY], [STAY], [NIGHT] key twice. This feature is used for
ARMING ONLY, and will not disarm the security system. This is ideal for a maid
or baby sitter, etc.
CHANGING MODES WHILE YOUR SYSTEM IS ARMED (Optional)
Double pressing the [AWAY], [STAY], or [NIGHT] key will change to the
corresponding mode. Once the AWAY mode is entered, the system must be
disarmed to change modes.

DISARMING YOUR SYSTEM

When you enter the protected area through one of the designated Entry/Exit doors,
the keypad control will sound a continuous tone for the duration of the entry delay
time, or until you enter a valid code.
1. Enter a valid user code.
2. The currently armed key [AWAY],
[STAY], or [NIGHT] will go off and the
tone will stop. The security system is now DISARMED. If a valid code is not
entered before the end of the entry delay, an alarm will occur. NOTE: If the
[AWAY], [STAY], or [NIGHT] keys are all flashing during the entry delay,
LCD Keypad
6\VWHP$UPHG
,QVWDQW
7\SH.RGHWR
'LVDUP
7