Other Keypad Functions; Setting The Keypad Tone; Change Partition; View Alarm Memory - Interlogix NetworX NX-6V2 User Manual

OTHER KEYPAD FUNCTIONS

SETTING THE KEYPAD TONE

Press [ ]-[0]. Keypad is now in the "Adjust Tone" mode.
Step 1
Step 2 Pressing the [1] key will make the keypad sounder go to higher
tones, pressing the [2] key will make the keypad sounder go to lower tones.
Step 3 When the desired tone is reached, press the [#] key to set this tone
and exit from the "Adjust Tone" mode.
CHANGE PARTITION – Optional
Step 1 Press [ ]-[1].
Step 2 Press a NUMBER key (1 or 2) to change partitions momentarily.
Step 3 If no other key is pressed, it will go back to its standard partition in
ten seconds.
Step 4 If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.

VIEW ALARM MEMORY

Step 1 Press [ ]-[3].
displayed on the keypad.
Step 2 The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed
during the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
Step 1 Press []-[4]. The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to si lence the siren.

WALK TEST

If enabled, it will permit a temporary walk-through test where all zones become
silent and do not report alarms to the central station.
Step 1 Press []-[Chime]-[user code]. During this test the chime light will
flash on the LED keypad.
Step 2 Each time a zone is faulted, the zone light on the LED keypad will
illuminate and the chime will sound. The number of the faulted
The zone(s) that created the last alarm will be
12