Interlogix NXG-183 Series User Manual

NXG-183x Series Keypad User Manual
EN
1
(2)
(5)
(8)
EN: User Manual
Description
The NXG-183x is an interface for users of the xGen family of
security systems.
Figure 1: NXG-183x Keypad layout
(1) Graphical screen
(2) Status LED
(3) Arm Stay button
(4) Arm Away button
(5) Functional buttons A, B, C, D
(6) System Info (i) button
Entering a PIN
You will need to enter a valid PIN to access various features
and system information.
After a period of inactivity, a screensaver will appear and the
keypad will go into power save mode. Press any button to
wake it up. A screen will appear requesting to enter your PIN.
A valid PIN is required to unlock the screen and access the
system.
Enter Your Code, then 
****
Enter a valid user code followed by Enter. User PINs can be
between 4 and 8 digits in length. The default master user PIN
is 1234.
© 2020 UTC Fire & Security Americas Corporation, Inc.
(1)
(3)
(4)
(6)
(7)
(9) (10) (11)
(7) Disarm button
(8) Cancel button
(9) Navigation buttons: Up (2),
Down (8), Left (4), Right (6)
(10) Enter button ()
(11) Selection button (5)
If the PIN is invalid for the feature you are trying to access, the
Access Denied warning message will be shown.
Permissions are assigned to users and keypads to determine
what features a user can access and at what times. If you are
unable to access a feature, contact your installation company
or building manager.
System status
The xGen security system displays system status messages
on the screen (Figure 1, item 1). For example, the main screen
below shows the Fault system status category.
Fault
Press i for Info
To get more details about the system fault, press the System
Info (i) button.
Other system status categories are Alarm, Bypassed, Not
Ready, Ready, Armed, etc.
Note that more than one system status category can be shown
at the same time. The screen will scroll through each category
automatically. You can manually scroll through them as well by
pressing Up (2) or Down (8) button.
Note: In the alarm condition, only the alarm status category
and messages are shown, until the alarm is acknowledged by
pressing the Disarm (Item 7) button and entering a valid PIN.
Other status categories are not shown in this state.
If prompted, press the System Info (i) button (Figure 1, item 6)
to display the list of messages on the current status category.
Zone in tamper
2 – Main Warehouse Ent_i
To scroll through multiple alarms in the category, press Up (2)
or Down (8) button.
Names of partitions or zones may not fit within the display. In
this case, scroll left or right by pressing the System Info (i)
button.
See also "System Status Messages" on page 6.
Status LED
The status LED (Figure 1, item 2) may show one the following
system statuses (starting from the highest priority):
•
Flashing red: Alarm
•
Blue: Fault, Programming Mode On, System Not Ready,
System is ready to force arm
1 / 8
P/N 466-5559 • REV A • ISS 04MAY20