Xerox Phaser 6121MFP Service Manual page 137

Phaser 6121MFP Service Manual
Error code: 0084
Definition: Detect DCN signal in phase B.
Solution:
1. Ask the sender to resend the fax.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0085
Definition: Transmitting unit sending DCS 3 times consecutively, but each time
responds with DIS/DTC.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Boost the machine TX Level.<*1>
Error code: 0086
Definition: Detected response signal other than DTC, DIS, FTT, DCN or CFR after
sending DCS.
Solution:
Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0087
Definition: Training attempt has failed because speed unit cannot adjust to low
lower speed.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Boost the machine TX Level.<*1>
3. Adjust the SOFT SW12[6-7] to "11", while receiving 4 PPR, the speed will down.
4. Change the machine TX speed to V.17, then resend again.
5. Print out the protocol report, and provide it to Technical Support for analysis.
Error Messages and Codes
3-31