Transfer Roll Failure - Xerox Phaser 6121MFP Service Manual

Error Messages and Codes

0094 Transfer Roll Failure

Initial Actions
Procedure
3-76
Possible causes:
• The 2nd Image Transfer Retraction Position Sensor(PS3) is not activated
(retracted position) within a given period of time after the retraction sequence
of the 2nd transfer roller has been started.
• The 2nd Image Transfer Retraction Position Sensor is not deactivated (pressed
position) within a given period of time after the pressure sequence of the 2nd
transfer roller has been started.
Power down and reboot the printer.
Troubleshooting Reference Table
Applicable Parts
2nd Image Transfer Retraction
Position Sensor (PS3), PL4.0.9
2nd Image Transfer Retraction
Position Solenoid (SD4), PL7.2.23
Main Motor, PL9.1.6
Engine Control Board, PL13.0.20
Troubleshooting Procedure Table
Step Action and Questions
1 Check the Main Motor connector
CN37.
Is the connector seated properly?
2 Check the Main Motor for proper drive
coupling and correct as necessary.
Does the problem persist?
3 Check the 2nd Image Transfer
Retraction Position Solenoid connector
CN5.
Is the connector seated properly?
Wiring and Plug/Jack References
Board Locations (page 2-10)
Sensors and Switches (page 2-11)
Motors, Fans, and Solenoids
(page 2-12)
Map 1 - Engine Control Board
Plug/Jack Locator (page 10-5)
Imaging Wiring (page 10-15)
Yes No
Go to step 2. Reseat the
connector. If
the problem
persists, go to
step 2.
Go to step 3. Complete.
Go to step 4. Reseat the
connector. If
the problem
persists, go to
step 4.
Phaser 6121MFP Service Manual