Table of Contents
Advertisement
For IBM PS/2 style computers with PS/2 mouse capability
1.
Your computer interface cables for this computer will be labeled either
CPIC-x or CPIF-x, depending on the options you ordered. Use the cable
diagrams below to locate the correct cable.
VGA VIDEO
PS/2 MOUSE
(yellow band)
CPIC- x CABLE
2.
Power down your computer, then plug the cable's keyboard, PS/2
mouse and VGA monitor connectors into the matching ports on the PC.
The mouse connector is denoted by a yellow band around its cable.
If you have the CPIF-x series cable, you will have three additional
connectors: two 3.5mm connectors for a microphone and speakers, and
a 9-pin D-shaped serial connector for a serial port. The microphone
connector is denoted by a blue band around its cable. Plug these con-
nectors into the appropriate ports on your PC or peripheral device.
3.
Attach the computer interface cable to the XP4000 Series unit by
plugging the 44-pin connector into the rear of the appropriate computer
interface module. Ensure that the connector is firmly seated, then
tighten the thumbscrews.
For XPAB modules using the optional ReBoot xP
To attach your ReBoot xP to your XPAB computer interface module, see the
section "The ReBoot xP" in Chapter 11.
KEYBOARD
23
VGA VIDEO
KEYBOARD
PS/2 MOUSE
MICROPHONE
(yellow band)
(blue band)
SERIAL PORT
SPEAKERS
CPIF- x CABLE
Hide quick links:
Advertisement
Table of Contents
