Dual Monitor Support - CYBEX XP4040 Installer/User Manual

Dual Monitor
Support
If your computer supports dual video monitors, the XPDU allows you to run the
second monitor through an XP4000 Series system. You must be logged on as the
administrator to configure this option. System requirements are as follows:
1) You must have two XPAC modules dedicated to the same computer
channel. These modules must be side by side in the chassis, with the
secondary XPAC having the higher address. For example, if your computer
is attached to an XPAC module in chassis address 1B, your secondary
XPAC must be located in 1C.
2) You must have two user modules - one to support each monitor. Your
primary user module must be the XPDU. The secondary user module must
be an XPLU. The XPLU must be dedicated solely to the second video
monitor in the system. These two modules do not have to be next to each
other, but it is recommended that they reside in the same chassis.
3) You will need an extra computer interface cable to connect the secondary
XPAC to a video port on your computer. Contact the sales department and
request the cable that is appropriate for your computer.
Note: If you are using the PC universal CPUC cable, you will need a SAD-3
adaptor as well. Contact the Sales Department to order.
4) You will need an extra user interface cable to connect the secondary XPLU
to your second monitor. Contact the Sales Department and request the
cable that is appropriate for your peripherals.
Connecting your Dual Monitor System
1) Connect your computer to your primary XPAC module as usual.
2) Connect a second computer interface cable between your secondary XPAC
and your computer's second video port. Leave the remaining connector(s)
on the cable unattached.
If you are connecting a CPUC universal computer interface cable, you will
also need a SAD-3 adaptor from Cybex. Attach this adaptor to the mouse
connector of the secondary CPUC cable. For more information, contact
Technical Support.
3. Connect the XPDU module to your keyboard, monitor and mouse as usual.
4. Connect a second user interface cable between your XPLU and secondary
monitor. Leave the remaining connector(s) on the cable unattached.
SUN COMPUTER
XP4040
X X X
X
P P P
P
AC INPUT
90-240 VAC, 47- 63 Hz
A D L
A
C U U
C
1 AMP FAST BLOW
250 VAC
102
PRIMARY VIDEO SECONDARY VIDEO