Attaching Computers To An Xp4000 Series Unit; Attaching A Pc Computer - CYBEX XP4040 Installer/User Manual

3
Attaching a PC
Computer
XPAC module shown
Attaching Computers to
an XP4000 Series Unit
Before you connect your PC to the XP4000 Series unit, you will need to configure
and install your computer interface module. The XPAC, XPAB and XPAL
computer interface modules have one set of DIP switches to configure. The XPAC
and XPAB also have jumpers to configure. Follow the steps below to configure
each XPAC, XPAB or XPAL module that will be connected to a PC computer.
Configuring your computer interface (XPAC/XPAB) modules
Configuring the Jumpers
The jumpers on the XPAC/XPAB module are used to control the video
selection settings. The default is IBM VGA/SVGA video. If the computer you
are attaching supports this video mode, no adjustment is required and you may
proceed to the DIP switch settings.
DIP-SWITCH
ASSEMBLY
Orient your XPAC/XPAB module so that the 44-pin connector is to your right
as shown above. Locate the jumpers on the lower right hand corner of the
board. The XPAC will contain JP1 - JP6; the XPAB module will only have
jumpers JP1 - JP5. Configure your XPAB module as you would an XPAC,
ignoring all references to JP6.
Use the diagrams below to configure the video settings for the PC computer
that you will attach to this computer interface module. You may wish to
consult your computer or video card reference manual for the video rates
supported by your computer.
1 2 3
1
2
3
4
5
6
*
IBM VGA/SVGA
* XPAC Modules only
44-PIN
CONNECTOR
VIDEO
JUMPERS
1 2 3
1
2
3
4
5
6
*
IBM XGA
17
IBM VGA/SVGA
(DEFAULT)
1 2 3
1
2
3
4
5
6
*
IBM XGA II