Appendix F - CYBEX XP4040 Installer/User Manual

Appendix F

Summary of Keyboard Control and Operational Commands
Below is a summary of all notational conventions used in this manual.
Whenever you see one of the symbols listed on the left side of the table,
substitute the corresponding steps or values listed on the right side of the table.
Convention Key Sequence or Value
Enter Command Mode:
<CM> 1.Press and hold down the 'Num Lock' key.
2.Press and release the minus (-) key on the numeric keypad.
3.Release the 'Num Lock' key.
<Enter> Press the 'Enter' or 'Return' key. The <Enter> command is used to
execute an instruction and exit from Command Mode.
Addr Enter the letter that corresponds to the channel you wish to select.
<ESC> Press the 'Escape' key. The <ESC> command is used to exit
Command Mode without executing an instruction.
The following is a summary of all commands used.
Key Sequence
<CM> Addr <Enter>
<CM>KD nn <Enter>
<CM>KG<Enter>
<CM>KH<Enter>
<CM>RESET<Enter>
<CM>RESET Addr <Enter> Resets any module in the system, computer or user. Replace
<CM>OFF<Enter>
<CM>M+<Enter>
<CM>MW+<Enter>
<CM>ZF<Enter>
<CM>ZB<Enter>
<CM>ZS<Enter>
<CM>ZQ<Enter>
Action
Selects an active computer channel with the keyboard.
Configures the dwell time. Substitute nn with a value from 1 to
65 seconds. The default value is 5 seconds.
Enables the KeyScan Go command.
Enables the KeyScan Halt command.
Resets the active user module.
Addr with the address of the module to reset.
Logs a secondary user off of the system. User screen goes
blank. Video channel is freed up for other users in the system.
Selecting a channel re-enables the user.
Re-enables the mouse on the current active channel. Use
after a mouse failure, after switching the type of mouse
connected to a user station, or after the RESET command has
been used on the active computer interface module.
Re-enables the Microsoft IntelliMouse on the current channel.
Starts the Configuration Menu if you are connected through
an unattached computer.
Starts the Configuration Menu if you are connected through
an attached computer.
Starts the Configuration Menu if you are connected through
the serial mouse port of an XPLU module.
Quits the Configuration Menu.
141