Minolta Di450 Service Manual page 95

(4) Positioning of the PC Drum Paper Separator Fingers
(Separator Finger Solenoid)
Requirement
The gap between the three PC Drum Paper Separator Fingers and the PC Drum should be
0.3 to 1.0 mm when the Separator Finger Solenoid OFF.
NOTE
Use care not to deform the Separator Fingers during the adjustment procedure.
Adjustment Procedure
1. Attach the PC Drum Paper Separator Finger Posi-
tioning Jig to the Developer Unit.
1136D053AA
2. With the Separator Finger Solenoid in the deener-
gized position, adjust the position of the three
Paper Separator Fingers using an Allen wrench.
4002D212AC
Adjustment Instructions
• With the solenoid in the deenergized position, the tip
of the finger should be at a point between A to B
end.
• With the solenoid energized, the tip of the finger
should touch C.
1136D055AA
NOTE
If the requirements are not met, loosen the hexagon
socket head screw, loosen the two screws indicated on
the left, reposition the solenoid, and make the adjust-
ment once again.
4002D213AB
D-76