Minolta Di450 Service Manual page 176

2. Setting in the RD Mode
Touch Panel
Display
System Set Set the control system.
Billing Center Displays the various setting screens.
DT Setting Displays the setting screens for CT-ID, DT-ID, and telephone number.
The mail address is also displayed if "e-mail" is set for System Set.
CT-ID Enter the ID number of the Center PC from the 10-Key Pad.
DT-ID Enter the ID number of the Data Terminal from the 10-Key Pad.
TEL No. Enter the telephone number of the modem connected to the Center
PC.
Initial Performs the initial transmission from the PPC to the Center to check
Transmission for correct communication after the Data Terminal has been set up.
Billing RAM Clear Initializes the Data Terminal settings.
Maint. Center Displays the various setting screens.
ID Code Enter the ID code.
<Procedure>
1. Touch the ID Code key.
2. Enter the ID code from the 10-Key Pad.
3. Touch the ID Code key. (This executes the transmission of MAINT.
DT Setting Displays the setting screens for CT-ID, DT-ID, and telephone number.
The mail address is also displayed if "e-mail" is set for System Set.
CT-ID Enter the ID number of the Center PC from the 10-Key Pad.
DT-ID Enter the ID number of the Data Terminal from the 10-Key Pad.
TEL No. Enter the telephone number of the modem connected to the Center
PC.
Initial Performs the initial transmission from the PPC to the Center to check
Transmission for correct communication after the Data Terminal has been set up.
Call Completion Transmits the signal of notifying the completion of service job to the
Center.
Maint. RAM Clear Initializes the Data Terminal settings.
e-mail
YES
START to the Center.)
YES
S-35
Setting
Modem
NO
NO