Minolta Di450 Service Manual page 62

Coupling Holder
Collar
11. Remove the PC Drum Paper Fingers and AIDC Sensor Board as shown below.
AIDC Sensor Board
NOTES
• At removal and reinstallation, use care not to damage the tip of the fingers.
Also, use care not to get hurt by the tip of the fingers.
• After reinstallation, perform the following adjustment procedure: Positioning of the PC
Drum Paper Separator Fingers.
D-76
PC Drum Paper Separator Finger Installed
Top View
NOTE
When reinstalling the PC Drum Paper Separator Fin-
ger Holder Assy., fit the collar of the assy onto the cou-
pling holder in the rear.
1134D047AA
Rear View
1156D063AA
D-43
Assy
4002D128AB
Hook the spring property.
After installation, check that the
Paper Separator Fingers operate
smoothly.