Minolta Di450 Service Manual page 125

(3) Adjustment of the Upper Right Door (Multi Bypass Unit)
If the Right Door has been removed and reinstalled, the position of the actuator of Upper
Right Door Set Sensor may deviate from the correct position. Hence, the necessity of the
following adjustment.
1. Lifting the front end slightly, tighten the two mount-
ing screws.
NOTE
At this time, only temporarily tighten these screws.
4002D220AB
2. Lightly close the Upper Right Door so that the Set
Sensor actuator will not contact the frame.
4002D221AA
3. Due to its own weight, the front end of the Upper
Right Door tends to hang lower. Lifting the front
end slighting the two mounting screws.
4002D222AB
4. Open and close the Upper Right Door two to three
times to make sure that the actuator of the Upper
Right Door Set Sensor does not contact the frame.
4002D223AA
D-106