Minolta Di450 Service Manual page 41

8. Remove three screws and the Power Supply Board
Mounting Bracket Assy.
4002D070AB
9. Remove three screws and the Flywheel.
4002D071AB
10. Remove three screws and the Transport/Synchro-
nizing Rollers Drive Assy.
4002D073AB
11. Snap off the E-ring and remove the gear.
12. Unhook one spring and snap off one E-ring. Then
remove the bushing from the rear end of the Upper
Transport Roller.
13. Snap off one E-ring and remove the bearing from
the rear end of the Lower Transport Roller.
4002D239AC
14. Remove three screws and the Cover.
NOTE
Do not remove the belt mounting screw on the cover.
4002D075AB
D-22