Remote Access Code - AT&T CLP99183 User Manual

Answering system
Answering system settings
Using the telephone base:
1. When the telephone base is in idle mode, press
enter the main menu.
SELECT
2. Press
3. Press q
CALLER ID
setup, then press SELECT.
4. Press q
CALLER ID
then press SELECT.
5. Press q
CALLER ID
2, 3, 4, 5, 6 or Toll saver.
SELECT
6. Press
NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the caller
ID announce feature may not have enough time to announce the caller's full information.

Remote access code

To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset:
1. When the handset is in idle mode, press
main menu.
2. Press q or p
CID
press SELECT.
3. Press q or p
CID
press SELECT
4. Press q or p
CID
press SELECT.
5. Use the dialing keys to enter a
/DELETE to backspace and delete a digit.
MUTE
SAVE
6. Press to save the setting. You hear a confirmation tone.
to select Answering sys.
or p
DIRECTORY
or p
DIRECTORY
or p
DIRECTORY
to save the setting. You hear a confirmation tone.
to scroll to Answering sys, then
DIR
to scroll to Ans sys setup, then
DIR
to scroll to Remote code, then
DIR
to scroll to Ans sys
to scroll to # of rings,
to choose among
MENU
two-digit number. Press
108
ANS SYS SETUP
Cal l screening
MENU to
# of rings
Remote code
BACK
# OF RINGS
6
5
4
BACK
to enter the
SELECT
SELECT
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
R E M O T E C O D E
19
BACK SAVE