Answering System; Answering System Settings; Announcement - AT&T CLP99183 User Manual

Answering system

Answering system settings

Use the answering system menu of a system handset or the telephone base
to set up the announcement message, turn on or off the answering system
or message alert tone, activate call screening, or change the number of rings,
remote access code or message recording time.

Announcement

Your outgoing announcement plays when calls are answered by the
answering system.
The telephone has a default outgoing announcement, "Hello. Please leave a
message after the tone." You can use this announcement, or record your
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To play your current outgoing announcement:
Using a cordless handset:
1. When the handset is in idle mode, press
the main menu.
2. Press q or p
CID
press SELECT.
SELECT
3. Press
4. Press q or p
CID
press SELECT.
Using the telephone base:
1. When the telephone base is in idle mode, press
MENU
to enter the main menu.
2. Press SELECT
3. Press SELECT
4. Press q
CALLER ID
then press SELECT.
to scroll to Answering sys, then
DIR
again to select Announcement.
to scroll to Play annc, then
DIR
to select Answering sys.
again to select Announcement.
or q
DIRECTORY
MENU to enter
to scroll to Play annc,
101
own.
ANSWERING SYS
Announcement
Delete al l old
Record memo
BACK SELECT
Playing
announcement...
RECORD STOP
ANSWERING SYS
Announcement
Delete al l old
Record memo
p
SELECT
BACK
q
Playing
announcement...
p
RECORD STOP
q