Ip Igmp Static-Group - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

4-2 ip igmp static-group

ip igmp static-group GROUP-ADDRESS
no ip igmp static-group GROUP-ADDRESS
Syntax Description
GROUP-ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip igmp static-group 233.3.3.3
CLI Reference Guide
Use this command to directly add an interface to a group. You can use this
command to add an interface to a group. Use the no form of this command to
remove the setting.
Address of the multicast group. This is a multicast IP address in four-part dotted-
decimal notation.
The switch is not added to the multicast group manually.
Interface configuration mode
This command directly adds an interface to a multicast group. You can use this
command to add an interface to a group.
Use command show ip igmp groups static to verify your setting.
Following example is to add a host group member manually:
ip igmp static-group
209