Setting The Scan Reference Distance - Konica Minolta Vivid 910 Instruction Manual

Setting the Scan Reference Distance

If the entire object is not completely within the effective scan range and a part of the front or back of the object
is not scanned, press at the end of scan, shift the reference position back or forth as described below, then
perform scan again.
[Operating Procedure]
The following procedure must be carried out if images acquired when scan was performed as explained on page
30 are unsatisfactory.
1
Perform scan and press
The currently set laser power will turn to pink.
R
For a description of adjusting the laser power, refer
ef.
to page 37.
2
Press .
The currently set CCD gain will turn to pink.
R
For a description of adjusting the CCD gain, refer to
ef.
page 37.
3
Press .
The currently set scan reference distance will turn to
pink.
4
Press and set the desired scan refer-
ence distance.
If the acquired image lacks a front part of the object,
set the scan reference distance closer to you.
If the acquired image lacks a back part of the object, set
the scan reference distance away from you.
<Settings>
• 600 to 2500: Scan reference distance (Unit: mm)
M
emo
Pressing will change the value in steps.
at the end of scan.
Scanning the Object
39