Notes When Using The Instrument With Tripod; Mounting To The Tripod - Konica Minolta Vivid 910 Instruction Manual

Non-contact 3d digitizer
Hide thumbs Also See for Vivid 910:
Table of Contents

Advertisement

Notes When Using the Instrument with Tripod

When using the instrument with the tripod, first attach the tripod base plate to the instrument, and then attach
the instrument to the panhead/tripod. To improve scanning accuracy, it is recommended that scanning be per-
formed via the personal computer connected to the instrument, instead of pressing the [RELEASE] key.
CAUTION
• Make sure that the tripod base plate, panhead and tripod are secured to the instrument and each fas-
tener on the tripod is firmly tightened. Failure to observe this point may result in the tripod overturning
or the instrument dropping.
• When placing the tripod on a floor, examine the floor conditions and flatness to make sure that the tri-
pod is stably placed.
• After measurement is completed, the instrument must be removed from the tripod before storing them.
If the instrument is stored with the tripod attached, the tripod may overturn or the instrument may drop,
resulting in accidents.

Mounting to the Tripod

1. Mounting the Tripod base plate to the Instrument
Before mounting the instrument to the tripod, mount the tripod base plate to the instrument as explained below.
M
emo
• Five screw holes for the tripod base plate are provided on both the top and base of the instrument.
• The instrument can be attached upside down to the tripod. In this case, remove the handle from the top of the instrument,
mount the tripod base plate on the top of the instrument, then mount the handle on the base of the instrument.
[Mounting the Tripod base plate]
1
Make sure that the power to the instrument is
OFF, and remove the power cord.
2
Turn the instrument slowly so that its side fac-
es down, and place it on a flat table.
3
Place the tripod base plate on the base (or top)
of the instrument, and secure it with the five
screws (supplied with the tripod base plate).
* Make sure that screw washers are fitted into the dents
on the base of the instrument.
4
If you have removed the handle from the top of
the instrument, attach it to the base of the in-
strument.
22
Tripod Base Plate

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vi-910

Table of Contents