Table of Contents
Advertisement
2. Mounting the Instrument to the Panhead
After you have attached the tripod base plate to the instrument, they need to be mounted to the recommended
panhead as explained below.
First, remove the accessory plate from the panhead, attach it to the instrument, then attach both to the panhead.
M
emo
Three screw holes are provided on the back of the tripod base plate (the side with rubber feet), to allow mounting the tripod
base plate to the panhead.
[Attaching the Accessory Plate]
1
Remove the accessory plate from the pan-
head.
2
Place the top of the accessory plate on the tri-
pod base plate (attached to the instrument),
and secure them with two screws (U3/8, sup-
plied with the accessory plate).
[Attaching to the Panhead]
1
Make sure that the tripod/panhead is secured in place.
2
Remove the rubber feet on the base plate with the use of a hexagonal wrench.
M
emo
Remove the two rubber feet located at the rear.
N
ote
• If the instrument is to be removed from the tripod/panhead and located on the base plate, attach the rubber
feet.
• Store the rubber feet in a safe place after removal.
3
Slide the accessory plate (attached to the tripod base plate on the instrument) into the
panhead.
4
Tighten the slide fixing knob to firmly secure the accessory plate to the panhead.
M
emo
Refer to the tripod/panhead instruction manual for details on using the accessory plate locking knob.
Notes When Using the Instrument with Tripod
U3/8 Screw
Accessory Plate
23
Advertisement
Table of Contents
