Setting The Terminator - Konica Minolta Vivid 910 Instruction Manual

Setting the Terminator

The VIVID 910 has a built-in SCSI terminator. The terminator is required if the VIVID 910 is the last device
of those connected in series to the SCSI interface (i.e., if only one of the SCSI ports on the VIVID 910 is used).
If the terminator is not set correctly, the VIVID 910 or devices connected to the SCSI interface may
malfunction.
M
emo
"ENABLED" has been selected as the default setting before shipment.
N
ote
"DISABLE" must be selected if the VIVID 910 is connected via the SCSI interface but is not the last device of those
connected in series, and "ENABLE" must be selected if it is not connected via the SCSI interface. (An error message
will appear if "DISABLE" is selected even though the VIVID 910 is not connected via the SCSI interface.)
[Setting Procedure]
1
Press .
The MENU view will appear.
2
Press to locate the arrow cursor to
"CAMERA SETTINGS".
3
Press .
The CAMERA SETTINGS view will appear.
4
Press to locate the arrow cursor to
"TERMINATE".
5
Press .
The currently selected option (ENABLED or DISA-
BLED) will turn to pink.
6
Press to select "ENABLED" or "DISA-
BLED".
<Settings>
• ENABLED: Select this option if the terminator is to be
used.
• DISABLED: Select this option if the terminator is not to
be used.
Connecting the VIVID 910 to a Computer
19