Removing The Preset / Tuning Switch Board; Removing The Operation Switch Board - JVC MX-G950V Service Manual

MX-G950V/MX-G880V
MX-G850V/MX-G750V
Removing the preset / tuning switch
board
Prior to performing the following procedure, remove
the display system control board.
1. Pull out the preset knob on the front panel.
2. Remove the four screws R attaching the preset /
tuning switch board.
3. If necessary, unsolder FW901 on the preset / tuning
switch board.

Removing the operation switch board

Prior to performing the following procedure, remove
the display system control board and the preset /
tuning switch board.
1. Pull out the volume knob on the front panel and
remove the nut. Pull out the sound mode knob, the
mic level knob and the sub woofer level knob toward
the front.
2. Remove the twelve screws S
operation switch board.
3. Release each tab of the seven joints g retaining the
operation switch board.
1-14
(See Fig.33, 34)
(See Fig.34, 35)
attaching the
Joint g
Joint g
Preset / tuning switch board
R
R
FW901
(Solding)
Fig.33
Preset knob
Volume knob
Fig.33
Joint g
S
S
S
S
Joint g
Fig.35
Sound mode knob
Sub woofer
level knob
Mic level knob
Nut
S
Operation
switch board
S
S
Joint g