Removing The Cams R1/R2 Assembly And Cam Gear; Removing The C.g. Base Assembly - JVC MX-G950V Service Manual

MX-G950V/MX-G880V
MX-G850V/MX-G750V
Removing the cams R1/R2 assembly
and cam gear q(See Fig.22)
1. Remove the slit washer fixing the cams R1 and R2
assembly.
2. By removing the two pawls "w" fixing the cam R1,
separate R2 from R1.
3. Remove the slit washer fixing the cam gear "q".
4. Pull out the cam gear "q" from the C.G. base assembly.

Removing the C.G. base assembly

Remove the three screws J retaining the C.G. base
assembly.
[Caution] To reassemble the cylinder gear, etc.with the
cam unit (cam gear and cans R1/R2 assembly),
gear unit and drive unit, align the position of the
pawl "x" on the drive unit to that of the notch on
the cam gear "q". Then, make sure that the
gear unit is engaged by turning the cam gear
"q" (See Fig. 24).
1-24
(See Fig.22 and 23)
Slit washer
Cam gear q
J
Fig.22
Cam gear q
Notch
x
Pawl
Cylinder
gear
Drive unit
Fig.23
Slit washer
Cam R2
w
Pawl
w
Pawl
Cam R1
Cam switch board
C.G. base assembly
Cam R1, R2 assembly
Gear unit
Gear bracket